Select the Tools tab on the Touch Screen.

Press the Machine Status button on the Control Panel.

See the Related Content for additional information.

Rotate the two securing screws to the right until both screws are tightened.

Grasp the two ring tabs on the new unit, insert the unit into the printer, and then push it in until it locks into position.

Remove the new Fuser Unit from its packaging.

If the instructions or shipping label are not available, click on the link under Related Content for additional information. NOTE: To return the used Fuser Unit for recycling, follow the instructions included with the new unit.

Grasp the two ring tabs on the left and right side of the Fuser Unit, and then pull the unit out of the printer.

Rotate the two screws that are securing the Fuser Unit to the left until they are completely loosened.

Lift up on the release lever on Cover A to open the cover.

Open the Bypass Tray (Paper Tray 5) by lowering it down.

Grasp the two ring tabs on the left and right.

Rotate the two screws that are securing the Fuser Unit to the left until they are completely loosened. Lift up on the release lever on Cover A to open the cover. Open the Bypass Tray (Paper Tray 5) by lowering it down. Press the main power switch located behind the Front Cover to the off position. Press the main power switch located behind the Front Cover to the off position.Press the power switch located on the Lower Center Tray to the off position.Power off the printer using both power switches, and then allow the printer to cool down for at least 40 minutes.ĬAUTION: Make sure to turn off the power switch located on the Lower Center Tray first, and then turn off the main power using the power switch located behind the Front Cover.

Avoid any contact with internal parts of the unit. WARNING: The Fuser Unit may be very hot and should be handled with care! Use the lifting handle provided on the Top Cover to avoid any contact with hot surfaces during removal or replacement. NOTE: A video is available at the end of this solution.

E studio 3555 separation roller